Please make sure to check them before using X-SCANNER

• To operate X-Scanner, please turn the ignition on to run “IROAD Smart Manager” app or OBD setting (T10s2).
  (Only can set during driving mode)

• After applying the X-SCANNER Firmware and DB update, please make sure to save the vehicle settings again.

• Please enter the vehicle information (Year/Type/Fuel Efficiency etc) based on the vehicle registration card.

• There may be some limitations of X-SCANNER function depends on vehicle grade and option.

• When Mercedes with “Mercedes me connect” is turned on, “Mercedes me connect service restriction” message may be displayed. However, there is no problem when using it. If you install a dedicated Mercedes diagnostic device or other OBD II, the above scenario may occur too.

• For some hybrid vehicles and vehicles that uses two different types of fuel, fuel economy information may differ from the actual.

• In cases of electric vehicle, fuel consumption is not supported. But, battery charge rate is supported instead of fuel level.

• For some electric vehicles, dashcam only enters driving mode when the vehicle is moving.

• The fuel consumption on the X-Scanner may be inaccurate until a calibration occurs.

• X-Scanner may not work when the X-Scanner and other company’s OBD are bridged by Y-Cable mode.

• Vehicle is equipped with DCT does not provide the transmission oil temperature value, so it is not shown.

• Troubleshooting code supports international standard diagnostic code (after 2010).

• If the OBD II was set to different vehicle more than 7 times for miscellaneous reasons or changing cars, the X Scanner will not properly function and there will be no compensation in such case. However, there are no limited amounts of numbers to set the OBD II when it is being connected to the same vehicle.

• KOBD can be set by mobile application only.